Skip to content

How to Create a Full Soil Moisture Release Curve

Two Old Problems

Soil moisture release curves have always had two weak areas: a span of limited data between 0 and -100 kPa and a gap around field capacity where no instrument could make accurate measurements.

Plant sprouting from the soil

Using HYPROP with the redesigned WP4C, a skilled experimenter can now make complete high-resolution moisture release curves.

Between 0 and -100 kPa, soil loses half or more of its water content. If you use pressure plates to create data points for this section of a soil moisture release curve, the curve will be based on only five data points.

And then there’s the gap. The lowest tensiometer readings cut out at -0.85 MPa, while historically the highest WP4 water potential meter range barely reached -1 MPa. That left a hole in the curve right in the middle of plant-available range.

New Technology Closes the Gap

Read more

Download the “Researcher’s complete guide to water potential”—>

Download the “Researcher’s complete guide to soil moisture”—>

No comments yet

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.